Recent content by DodgeyWill

  1. D

    Stock 360 with bolt ons - options

    If it didnt have nice headers and carb I'd look at that, probably wouldn't go chinese though!
  2. D

    Stock 360 with bolt ons - options

    Thanks all, I am a novice to mopars so appreciate the advice. I'm going to compression test it tonight, if it's good I'll leave the block be and settle for a cam to try and squeeze some more from it since you all think it's worth it. Whilst I'm testing it I'll get all the numbers off the heads...
  3. D

    Stock 360 with bolt ons - options

    Thanks guys, the cam is just stock 360 spec as the rest of the block, idle is dead smooth. Not against changing cam and springs, will I see any power gains with a hotter cam on such low compression or do I need to start looking at pistons or head milling? Would like to avoid pulling the engine...
  4. D

    Stock 360 with bolt ons - options

    Just set my initial to 20 degrees at the weekend. Was showing 35 max. Vacuum at idle was actually just into over run on my vac gauge. Not got a sensor to tune no, would I need a boss in the header for one?
  5. D

    Stock 360 with bolt ons - options

    Hi all, got what I'm 99% sure is a stock 1986 360 with 727 driving an 8.25 rear with 3.23 gears in a 67 dart. It's got an edelbrock avs2 650cfm carb, old msd 6al with hei distributor and dougs ceramic headers with big twin pipes cut at the axles. Engine seems healthy and it runs well, but I'm...
  6. D

    New on FABO

    Hi all, got my first mopar last September. She's a 67 dart and came from Idaho, now lives in Lincolnshire, England. Was recommended Fabo by a mopar specialist in the UK who says theres some really knowledgeable people on here. Look forward to learning more about these cars. Will
Back
Top