Recent content by Don Selleck

pm sent

pm sent

cool what do you need to get out of them I'm in michigan 49201. and do you have paypal etc.?

i do i need both of the cables also looking for the detent roller mech. that the park cable connects to, if you might have that. would be interested in the cables anyways, I assume they are in working order? Thanks, Don.

looking for a set of decent cables and inside trans mech. where the cable connect to for drive selector, or whole trans. thanks, Don

make sure its dry and clean, dehumidifier will help drier the better then block sealer, prep is the answer for good bonding.

way cool would like to see the total cost for that build

I bought one of those works pretty also has a disable command on it if you hook it up. comes with obd port plug in or you can cut the connector and wire to it to a constant power source, and it tells you if the ignition is on

I have a free td40 subaru turbo with less than a 1000 miles on it, in brand new condition and a few goodies including an intercooler to go with it, thinking I will be working with this instead of the sts system. spooled up on a 4 cylinder at around 3200, might be the answer, probably using the...

I'm contemplating a remote turbo build also, with a slant six, some very good info here on some of the things i was wondering about. I was only going to run around 8 psi, nothing too wild with 600 mechanical secondary blow thru, 9:1, forged piston and lighter rods just for insurance. powering a...

sounds good, so then your selling just the 23 spline gear box anything els with it? thanks.

tail shaft can be dealt with either way o.d. would be better, but not neccesarily a deal breaker

its going in this,the leaning tower of power with a turbo set up and a pistol grip shifter of course.

yes pretty much everything and a donor crossmember wouldnt hurt either

looking for one to bolt up to a slant six the more complete the better doing a conversion.