Recent content by Dragnut

Sorry, I didnt realize my email was full...I will get back to ya on the wheel size

1966 Dodge Dart, This car was completely stripped of the drivetrain and suspension and replaced with a coilover front conversion and a 4 link with a Dana 60 rear. The parts list is long but here is a few of them: 408 Small block built by IMM Engines 533 HP on the Dyno( have all dyno info)...

Thank You...!!!

Can anyone tell show me a picture of the rubber truck seal installed ? I am not sure what side gets glued down....I did a search and could not find a picture

1963-1966 A Body Bucket Seat Brackets in good working condition. The one side is missing the wire that goes in-between the brackets. I can ship these at extra cost. $375.

Sorry i dont know the guy, but I do live in Pottstown Pa..

Thanks for that info, so the reinforcing plates go on top of the floor not underneath?

Im actually using some Smittybuilt low back bucket seats with 65 Dart Gt bucket brackets. They will fit width wise. Thanks for the info

So im getting ready to convert my 66 Dart from Bench seat to buckets, does anyone know if the floor is dimpled for buckets from the factory? Or do I have to basicly make my own holes?

Ok Mike

Did you use the stock mounting brackets on these or make your own?

Wow those look killer...!!

OK...I have grown tired of the search for original bucket seats for my 66 Dart, can anyone recommend some aftermarket seats that will fit ?

I have a good original radiator from a 1966 V8 Dart. Located in Pottstown Pa. Please PM me for more info. $225.