Recent content by Dustert73

1968 440 hp engine with a 727. Engine is stuck from sitting I believe. Looks pretty complete aside from the air cleaner. Cash or PayPal only. Willing to trade for 5.7 hemi stuff or complete two post car lift. 2500$ Located in casstown Ohio 45312

Mopar A body a833 OD 4 speed transmission. Cleaned and rebuilt with brewers performance synchros, gaskets, seals, and needle bearings. Input shaft retainer has been dimpled to use an American powertrain hydraulic throwout bearing, but a traditional throwout setup can still be used. The...

I’ve got a dewalt 20v weed wacker, been using it for 5 years. Matches battery’s with my saw, drills, and impacts. Use dewalt stuff at work and they take gnarly chemicals on the chin like a champ

Battery tender, VBand clamp and PCV valve spoken for

56-0821 56-0819 Sway bar bushings from lmc truck for a first gen dodge truck

Dana Spicer Drivetrain Products 708203 Spicer Drivetrain Products Differential Clutch Disc and Plate Kits | Summit Racing

https://www.napaonline.com/en/p/ECHOP6603

I’ve got a bunch of stuff free for pickup in Huber heights Ohio 45424. Six pack base is a bad molding the carb holes are too big. If you’re handy with fiberglass you could fix. Limited slip clutch plates were purchased for a 9.25 but probably work with other setups. Vband clamp is 2.5 diameter...

pm cleared out

Hey FABO, I’ve got some parts leftover from my 1983 dodge w150 build that I didn’t end up using. All new never used. Free for pickup in Huber heights, Ohio 45424. Please check pics for part numbers. I have this posted on ram charger central but there was no interest there. Figure I’ll post them...

Hey, all is good to go with it. I’ve been keeping up on an inspection schedule while it was in service. Currently it’s in storage for the winter.

I’ll take it if slant doesn’t buy it

Next in line

Classic run whatcha brung! The nicety of expensive headers is a cool upgrade for the future on your car. Not a necessity though.

Normal cheap header stuff. You have to fish the socket under that horizontal tube and either use some wobble extensions in the attempt to space outwards to get a ratchet or try to get your ratchet under that tube along with the socket and maybe a real small extension. Most spark plug sockets...