Recent content by DusterTim
-
In search for seat release knob!
Help! I been looking for the seat release knob shown in the picture for a Bench-Bucket seat. The knob is chrome with a radius-ed back side that has ribs on the arc part. Has a slot on the top side to attach to the seat. Looked every where and watching on Ebay for quite awhile but no luck, has...- DusterTim
- Thread
- Replies: 2
- Forum: Mopar General Discussions
-
-
8 3/4 brake lines
67'-69' 8 3/4 has the vent hole more to the middle of the axle and 70'-71' 8 3/4 has vent tube more on the axle tube, I just went though this problem myself. Sounds like you have the 67'-69' lines. Good luck, hope this helps.- DusterTim
- Post #4
- Forum: Brakes for your Classic Mopar
-
Tuff Wheel Repair
What I did was get inject weather strip glue with a sryinge from the back side so as not to be visible if a it left a mark. Then after injecting the glue rotate foam back and forth to spread glue. Do this in multi spots until satisfied with firmness. This worked very well!! Good Luck!- DusterTim
- Post #4
- Forum: Mopar Interiors