Recent content by E7polyhachett

DM sent.

I have a couple of pairs tthat will be all drilled off.... nice western pieces. They will be available at the All Chrysler Nationals in Carlisle. I'm not interested in shipping at this time.

Happy Birthday Dan! We appreciate everything and all you do for the site! :thumbsup:

This is exactly right! Yea, have some wurlitzer out there playing with himself that doesn't know **** from shinola! You have a member on here that can't even watch the bowl with his daughters because of that stool Pigeon! When I was a kid at home with family, we all sat around the t and v...

I would be very surprised if Speedway Motors wouldn't buy it. My friend Dave Crane's huge collection of rare hemi, and tons of speed parts were bought from Speedway Motors. The last race car Dave and good friend Clark Shaffer built was an altered with a blown 392 hemi, beautiful car. I believe...

Double check all of your ground cables or straps. Battery to the frame, ground the starter to the frame, and then a ground from the rear of block to the firewall. It needs to have clean shiny metal underneath all of the grounds.

I went back and tried to decipher the part number, and to me it says 438 something, something....... so I'm thinking newer like overdrive Trans, A-518 or A-999 maybe ......... IDK.

It not a 904 either, because from the inside edge of the driveshaft snout a 904 yoke has a taper from the inside edge back about 3/16" and then splines start there. I have never seen a yoke with the splines being curved out at the start of the yoke. I'll have to think on this one!

This is a huge loss in the camshaft industry! I remember looking through my dad's book collection at all the diff magazines, and everyone had big Ed Iskenderian advertisements! It was cool! R.I.P. The Godfather, Ed Iskenderian

Jim, I have a very nice complete panel from end to end removed from a 73 Duster. It's a no rust panel, and original paint.

I'm very sorry for your loss. R.I.P. What a great family history you have there with your brother!

I'll take it Ken!

DM sent.

My guess would be probably be off a 400 or 440. Like you said 72 and later pulley. It could of been on C body, truck, or RV, maybe something larger, with A/C. If you go to swap meets or other place, you may happen see one, and ask them if they knew what their pulley was picked from. I hope you...

I've never tried it....... just take into consideration that your 73 Dart Sport has rounded lower A pillar corners, and the 73 Swinger 2 and 4 dr lower A pillar windshield corners are more squared off in the lower bottom, hence there may be some difference in the dashboard frame corners. Like...