Recent content by Emeraldart

Looking for either tinted 1/4 glass assemblies or near perfect tinted 1/4 glass for 70-72 Duster 71-72 Dodge Demon. Driver side especially. please pm Thanks James Lower Mainland B.C. Canada

Probably have one...have to look...are your bumpers slotted? James

http://www.ebay.com/itm/Mopar-67-68-69-70-71-72-Dart-Valiant-Duster-Demon-Door-Window-Hardware-Kit-NEW-/360780132757?pt=Vintage_Car_Truck_Parts_Accessories&hash=item54002bf195&vxp=mtr sorry here is the correct link James

You can buy the parts on ebay...keep in mind you will need two sets one for each door..not cheap but factory repo parts and cheaper than pulling your hair out! Bought a set works fine...

Or you can use a stainless steel machine screw of the same length and diameter, with nut.

Thanks guys for your help...

Just finished installing my 360 and 727 transmission in my 71 Demon. The top two bolt sizes, left and right of centre are 3/8 coarse, the bottom 4 are 7/16 coarse...what sizes are the ones in between...the bolt hole where the transmission dipstick tube mounts and the opposite one on the other...

Great information on your wiring project, very timely and helpful! I am about 2 weeks away from rewiring my 71 Demon. Looks like I will go with the Highway 15 kit as I don't have a/c and will keep it very basic. I have one quick question on the P/N for the pigtail for the voltage...

Greetings.... Yes they should fit as I am running that combo on my 71 Demon...offset kit a must...James

My PST torsion bars finally arrived...see photo...they do have a left and a right, but come with no instructions. I probably won't be able to try installing them until next week. They don't appear to have any offset either. I will post back when the 'fun" begins...were you able to contact the...

The pitman arm is for 67-72 a body which is supposed to be the correct one for that after market steering box...Moog crossover number K7074...direct bolt in

Greetings once again, Purchased the flaming river 16:1 manual box and have it bolted to the K-member of my 71 Demon. I have tried installing a new DLZ brand p/n K7074 pitman arm but it is too tight and will not go on far enough...aprx 3/8 inch short of being flush...super tight to wrench...

Sireland67, still waiting for the PST bars to arrive...even though they are from a different manufacturer they should be nearly identical, as the diameter is the same....right now my LCA's are just sitting in the k-member loose and not tightened, this allows them to be at nearly the 6 o'clock...

can you PM me with any photos...really looking for the spindles..thanks James