Recent content by fcantre

  1. F

    Can anyone identify these heads?

    Did you ever wind up buying these heads and if so, how did they work out for you? What was the quality of them?
  2. F

    intake milling

    Thanks for the reply. Even with using RTV only, I assume at some point of cutting down the heads, the intake rails could hit the block before being tight against the heads if the rails are not cut down to match? My scenario is all uncut, virgin pieces. Regards, Frank.
  3. F

    intake milling

    Since the intake manifold will have to sit lower after milling the heads, is it necessary to mill the front & rear rail of the intake? If so, how much relative to the amount removed from the heads? Thanks for your time, Frank.
Back
Top