Recent content by Fenix13

Date on the block is 6/14/71. The pad on the passenger side has Paint on it, but it didn't seem to have a vin stamp. I'll check again but don't want to mess with removing the paint.

I have a rebuilt 340 that I picked up from a member about 3-4 years ago for my Barracuda build. Located in Moorpark CA Keith Black Performance Pistons - KB243-040 Hypereutectic Mopar Perf. ''Purple Shaft'' Hydraulic Camshaft Kit:Camshaft, Hydraulic Flat Tappet, Advertised Duration 268/272...

I'll get VIN tomorrow for you cracked, in the process of moving. For anyone else interested $2k OBO.

$2500 obo

50 bucks for anyone local has to go today

250 obo

200 obo

I'll even throw in an 833 OD I have listed with the deal.. $3K obo

Still got everything minus the 318 (pending sale), and the kick panels. Price drop $5K

Thanks for all of the info guys! It is a thermoquad carb, and I messed up it's an 800 CFM. Just want to make sure I give the best info I can on the motor, when we were sizing it up my mechanic and I must have been a little more optimistic. Thanks again guys!

Hi Joe, The early 833 don't have the raised stampings that the later transmissions had. The numbers on the castings are the only numbers on the transmission.

Yes flanged output, 23 spline input, came out of a 65 I believe... I don't recall the model it came from though. AJ is correct it's a ball detent spring, like $3-4... you can spend the big bucks and pick up a whole assembly kit for $20. More pics attached

Hi guys I've got a potential buyer a 340 engine I have, and the member is asking what kind of performance numbers should be expected. I was expecting to make between 350-400 HP from the build. Since it's never been ran, I wanted input from some of you folks more engine savvy than me, to make...

Hi Treblig, It comes with the heads, rockers, intake manifold, intake, carb, oil pump, I think I have the water pump too. I bent 1 of the push rods while pulling it, rookie mistake other than that... It's just been sitting for awhile in the shop.

I have a set of new in the box Classic Industries kicker panels with cut outs for speakers for sale located in Simi Valley CA. $60 shipped in the US.