Recent content by Ftw

You need two thick steel plates about one foot square and a big press , place the edelbrock carb between the plates , and press it until the snapping noises stop. Best thing for any carb based on a carter design , for the good of humanity. There is no way that tiny little cam should idle at...

Thanks, now I have to sell my soul for more cast aluminum.:burnout:

OK can we reverse this, will the glass fender for a 69 fit a 75, sorta? We ve been tripping over a set for years, while I ve been looking for fenders for my swinger.

I have one, sway bar on it, and I m probably north, and east of y'all

Alway check piston and valve guide clearance with a non stock cam, I had to cut guides and pistons with a tiny cam, apparently the block and heads had been decked a ton in its previous life. I purposely went small so I'd have no problems. Check the centrifugal advance on your distributor...

I can get a set of old cast aluminum Mickey Thompson valve covers, does anybody know if they'll clear roller rockers?