Recent content by fullfloater

That’s a little to far for me , thanks

Where are you located

Looking for a bare block 340 that will bore at least 060 over , don’t need a complete motor or other parts just a block . Live in Oklahoma so hopefully something in the central time zone . A X block would be nice.

I will take them PM Send a PayPal invoice to

I am interested , shipping included ?

Do you have any pics of cylinder walls that you think need sleeved . Is it pitted bad ?

Bought a winters floor shifter , it will not work , it has bellcrank right at the overdrive solenoid and hits the case . After 1 1/2 days of trying to modify it I have given up . Any recommendation on a floor shifter besides Lokar or American shifter that will work on a A518 . Going in a dodge...

Trans wouldn’t shift into overdrive , pulled pan and it had a lot brass in it , so pulling trans for rebuild . I talked to trans guy at dodge dealership and he’s been building Chrysler trans for 25 years , he said get a kit and bring me trans , said get extra thrust washers . I asked about heavy...

Pulled pan and it’s full of brass , tranny coming out . Thinking about buying a trans , it’s a 2 pin 518 . Any recommendations on buying a trans from a builder . They are few out there just want a good one without taking out a 2nd mortgage .

Looking for 8 3/4 third member with ration of 391 or 410 or 430 , no lockers , posi would be nice or open diff. . Close to Oklahoma would even be better . Thanks

Thank you ..

I just put a A518 in my 79 Warlock with the 2 pin connector non lockup convertor. Was a little chore but got it going , I wired a toggle switch to blue wire hot and orange etc wire to ground . I have no overdrive , have checked hot wire using pin ground on frame ground and it’s all good . Trans...

A pair of over the counter 576 small block heads ,these were the replacement 308 heads over the counter ,SS racers and circle track use these heads ,These heads have no porting done to them ,Ferra valves 2.02 intake 1.60 .aftermarker retainers ,comp springs ,These heads have been milled to a...