Recent content by Gandy Dancer

Just an update for the post - Instead of getting the frame straightened, I found a donor car and cut the front frame off of it, and welded up to my car. The car sits straight now, and I am starting to reassemble the body panels.

I'm having some difficulty uploading pics, but this is the front end after I removed the old 65Dodge Dart clip from it.

Tom - This is the donated 66 Barracuda front end that my buddy is going to weld on for me.

Ok sounds good.

Additional photo of the driver side.

A/MP - I've attached a couple of closer pictures. They do have some rust at the bottom where the fender buts up against the firewall, and I did mention the 8th of an inch I shaved off of the driver side for fitment.

These are some of the ones of the passenger side I took but I will get some better ones.

I will get some close up pictures for you tomorrow. But they are pretty much ready for paint. I did shave 1/8 inch off of the driver side for fitment. I will photograph that also. Not sure if you needed a hood, but I have that also. I will have better pics of all of them.

Sorry about that. The price is $350.00

For Sale 1965 Dodge Dart front Fenders. Both are in relatively good condition. The left fender had a 1/8 of metal shaved off of the back for fitment purposes. Other than that the fenders and grill are pretty decent.

Hello I was just about to put these 65 Dodge Dart Fenders on the board.

Hello - I wanted to add to this thread. I am in the Maryland area, and I have picked up a front end for my '66 Barracuda. Currently, the car is a Dart A Cuda. If you look closely at the car, on the driver side, you can see a slight downturn. The driver-side frame rail has about a 2.5 to...

Excellent. Thank you all for the information.

66 Barracuda left front frame rail.

Laracuda - I have what I believe is a 1967-1972 MOPAR A BODY K FRAME for a V8. I have it listed on the classifieds, but I believe I have it listed incorrectly. Take a look at the photos. It is not in bad shape.