Recent content by Gerald Lewis

That's a good point. I didn't think of it like that. So would I be fine with just a single disc in an 11 or 12" diaphragm pressure plate? I see a McLeod 11" with a sprung hub that says 3200 static pressure and a 12 inch with 2400 static pressure. Am I right to assume that the greater the static...

I just need a motor swap and clutch install done. If willing to do a little traveling if the shop is good.

Anyone know of any good shops in Atlanta GA?

Hi everyone, I've been running around in circles trying to decide on which clutch to get. I'm running a 470 low deck stroker, trick flow heads, solid cam I think 240/240 @50 and a rpm intake. Not sure on numbers since I haven't dynoed it yet. I was looking at centerforce df and it seems like...