Recent content by gt273

wanted gen 1 viper or dakota/durango rt wheel center caps

1966 dodge dart gt convertible original 273 four speed gt convertible gg1 paint code bought this a few years back for something to do after retirement and just about restored every nut and bolt on the car and i have reached the end of what im going to do to it and ready to move on to another...

Had brand new shaft made 54 1/2 inch center to center with my factory front 833 4 speed input 7260 front joint with 7290 rear 275 cash at pittsburgh driveline .butler st Works and looks perfect

thats what i thought. done dozens of these swaps but never ran into the 2 piece shaft before.

i have a 1966 dart with 273 four speed factory. i want to install a 489 8 3/4 rear. i thought i could just have the driveshaft shortened but its has inner shaft with the outer tube shaft. question is can this shaft be shortened to work? it has a factory 7 1/4 posi unit now. thanks in advance.

1966 dart driveshaft with 833 four speed and 8 3/4 rear. near pittsburgh will pick up. thanks

Product Identifiers Brand Cragar Manufacturer Part Number 1526753402B eBay Product ID (ePID) 19056710343 Product Key Features Finish Chrome Model Series 08/61 S/S Offset -6 Rim Diameter 15 Bolt Pattern 5x101.6 Number of Bolts 5 Hub Bore 71.63 mm Rim Width 8 Cragar 1526753402B Series 08/61 S/S...

1966 gt convertible

Also I did not have to remove overcenter spring

Yes

installed

picture 1- factory flywheel with bolts for 10 inch clutch aftermarket. ram powergrip clutch bolt pattern will not fit factory flywheel. factory takes 5/16 bolts picture 2- ram clutch and ram flywheel installed after drilling pressure plate for factory 3/8 pressure plate bolts. ram flywheel...

small bolt pattern , complete rear end wanted

wanted a body 8 3/4 in pittsburgh area

thought i would add my 66 gt convertible to the thread.