Recent content by gtx6970

NOS Prestolite dist vacuum advance unit All I know is its pre 1970 small block. It has a 7 on the link arm . Ive been advised. The actual application is 1965 273 cars But dont see why it wouldn't work on any other Mopar / Prestolite dist body $50 plus postage Paypal friends and family...

SOLD NOS mopar 3.55 ring and pinion set for a 741 case 8-3/4 rear diff. $250 plus shipping Paypal friends and family please. Or you cover the fees if you prefer goods and services USPS money order also an option. Or cash in Person. Im in Tucson AZ

Thanks for the pics. I have all 3 pieces and kind of figured it would be a fit then drill issue to make all 3 pieces fit nice and even. The rear bumper is off and may try to do some fitting tomorrow

I know this is a long shot. BUT, anyone by chance have an original decklid that they can measure the distance from the bottom edge of the decklid to the center of the hole where the clip stud goes thru I am adding a moulding pkg to a car and if avail it make it a lot easier to get the...

Art, I'll try my best to answer these here. But I am not the manufactuer, simply a dealer for said products. 1- I have my doubts an original was chemically tested for material construction/type 2 - Can't answer this one 3 - IMO, it's probably more of a cost related decision to use a more...

Now avail by limited purchase. The new reproduction exhaust manifold heat shield used on 1969 thru 1971 A and E bodies . Although it will work and function just fine on 1968 models. Technically they were different but are not avail in reproduction form. I've worked out a deal to get a limited...

Actually, I think it showed up in 1972 on B-bodies. ( maybe E-bodies ) then in 73 on all ( most ? ) models

Redfish, I feel your frustration. But keep in mind, I am not the manufacturer. But simply a retailer of someone elses product line. So I am at the same mercy as the end customer to a certain degree . Had you contacted the retailer from whom you bought it from, a free replacement would have been...

Art, I am not the manufacturer, but a retailer. but I do my best to answer these #1 - An original was used for the mold but I seriously doubt any plastic materials tests were done. #2 - I am sure the oriignal material is avail but problem is said material requires a much different...

Hello, Although some here already know who I am . I am Bill Allphin, I own and operate A+M Hightech Automotive This thread was brought to my attention recenly. So I thought I might be able to offer some insight on the subject. The first few shroud materials were an issue obviously, But...