Recent content by Hemi Dart

Finally got a chance to tear into my engine, it seems that the cam grinder didn't get the groove for my rocker arm oiling in the right spot. The groove was only partly covering the hole to the rockerarms. Thanks to everyone for the ideas and thanks to Muscle Motors for working with me on this...

Good Idea I'll try that Thanks

I primed motor when I installed the restricters, can't cut valve covers spark plugs are in them, the restricters are on the intake rocker shaft the oil passage splits when it goes into the rocker shaft support one to the intake and one to the exhaust rocker shaft. I'm thinking I will try a new...

Chamfer lifter hole? Checked for oil flow when I installed restricters, larger on restricters would let more oil go to Intake side, lifters are not bushed I need to pull lifter valley cover to check, lift is only .691 In. .652 Ex. something worth checking out. Indy Legend Hemi heads don't have...

Got a problem with #8 exhaust pushrod burning on the cup end, 572 Hemi with Indy Legend heads and roller rocker arms. Getting about 200-300 mi. before the lash increases, adjuster threads showing 1, restricters on intake side .043. All holes in rocker arm are open and holes in rocker shaft are...

Running a CSR on my 572 Hemi in a 67 Dart with a Be Cool radiator, no poblems on the street or highway, have driven to Mopars at the Red Barn about 150 mi.

Nats were good,weather was better than last year,the kid directing parking didn't have a clue as to what he was doing, got to watch more racing this year instead of looking through swap meet, even though I did wonder around it when things got slow, car corral had some interesting buys, Had a...

I used a K-frame from Hemispherical Products that was just redone by welding on the Hemi mounts, it has 1/4" spacers on it, as far as the pass side inner fender I cut out a piece almost to the shock stud, rewelded in a new piece that was flatter. But because I was going to put this motor in a...

I have one in my 67 Dart, tuff to break, heavy, can't change gears as easy as a 8 3/4, but sure looks good from behind, Moser & Strange both make complete rear ends any width.

Car 67 Dart Weight 3124 Gear ratio 3.73 Tire diameter 29.5 RPM through trap N/A MPH through traps N/A ET N/A Engine CID 572 Head Type Indy Hemi Valve size 2.3 I 1.94 E Head Work Super Mod Porting Cam Manufacturer Comp Cams Cam specs at 50 268 I 272 E...

Called Hagerty for a quote on ins. for the Dart, it was over $500 for $35000. Called Grundy and they cut it in half for the same amount.

Jessica is nice but she is not Barb Bach!

Going to be busy this weekend putting the tranny back in the Dart, had to replace the hyd. throwout bearing and clutch, underestimated power, put in Passon alum. case. If any of you guys are staying at Holiday Inn at the airport stop over and say hi. Probibly be in back parking lot, have to...

We just booked 25 rooms at the Holiday Inn at the airport, might still be rooms left.

I`m going along with about 20 other Mopars that are in the club I belong to, Tri State Mopars.