Recent content by hemicbx

Shipping would be to Mount Sidney VA 24467. Thank you

Do you still have the lower door hinges for this car? I’m looking for a set.

Direct message in your inbox on gas pedal. Thanks.

Yes, I’ll do that on the gas pedal. I’ll pm you. Thanks. Mike.

How about the gas pedal pivoting parts inside the car? Don't need the cable, just the pedal and the metal bracket up to the cable ball. Thanks, Mike

Hi Guys, I'm after the shiny trim piece that goes along the quarter window at the top of the body line. I have right side only, need a left or a pair. Pic is of the one I have: Thanks!

Looking for a set of straight strut rods for an A body. I have three, but only one is straight. Anyone have anything laying around already out of the car? Going into a 72. -Mike

Sorry my post is all jacked up. I won't do that from an iPhone again . . .

I just locked it all in there this weekend. I used the tti instructions as suggested. I redid the steel mount tabs on the frame as well. Also, as was noted, that hole likely cracked from flexing. I now have lateral limiters from plates on the block mount pad down to the cross member...

I'm looking for the light bulb holders for the rear side marker lights. I'm not sure how much wiring harness they're connected to or where the most logical break point is. Thoughts and price? -Mike

Good call mopowers! Offset 1-1/4" to the passenger side.

I've got a 70 dart drag car. It's a 440 car with elephant ears mounting the engine to the frame rails. There's nothing wrong with the setup and it has run very well in the 10.0 -10.3 neighborhood this way for years & years. This winter I pulled the motor and one ear was cracked at a water...

PM Sent

Hardline Products. I've used their numbers on several boats. Really nice quality and tons of color combos. I'll be using them on my car once I get a permanent number

RS23VOA & I have for sale a 66 Dodge Coronet 440 four door roller. This was someone else's restoration project that was cut short after it was started. The car is all apart, but seems to be all there along with some extras. There is a lot of prep work done. The underside of the car has...