Recent content by Ian McCrimmon

JB weld it-hone it-send it.

The hairspring sounds like the issue. I had a very small amount of knowledge about speedo operation. That would explain why the odo works but not the speedo. The question then is it preloaded with a set number of turns or tension? I guess I have to open it back up to see if it got damaged or...

So a brief description of the issues I am facing in getting my speedo working properly. First thing its an A903 3 speed behind a slant 6. The needle was broken off so I used a thin pin behind the needle and glued it in place. It worked after that but worked is a loose approximation-it bounced...

I always back into parking spots and taught my daughter to do the same. The wife-different matter! Its safer to back into a spot where there shouldn't be any vehicle or pedestrian traffic. And again safer to drive straight out into traffic with full forward visibility.

So reading through the posts a couple of things jump out. First the refund on RRSP contributions is based on a lot of factors including your marginal tax rate based on province of residence. If you are expecting a 50% refund you must be in a high tax bracket where your marginal tax rate is 50%...

Another video of the same crash. Warning-graphic.

My Wifes 2009 Jeep JK. Been her dream to own a Jeep instead of always getting the family hauler for her. And the heater core. If anyone knows about replacing the heater core In a JK you know how my Saturday went!

Thanks to #wilma got a complete drum to drum rear end. Now to compare three rear ends for two cars and see whats what.

Ha no wasn't pegged! On this trip the speedo started out about 20mph to low then after 90 minutes it started to howl and wrapped around to that point! I just unhooked the cable for the rest of the trip. That video was about 80 km/hr as per my cell phone app. Any higher in the revs and it would...

On the road trip this is right about where we pull over and refill the rad!

Empty your inbox.

Appreciate the offer. How much? And any idea what gear is in it?

Well I picked up another A-body (more on that later) and one of the rear drums has welded it to the brake pads and isn't coming off. We beat on it and my partner bent the heck out of the face of the drum and is cutting it off with a grinder. That being said we need a crappy brake drum ASAP just...

Chugging usually indicates a blockage in the exhaust system.

Ginger beef-Calgary mid 1970s