Recent content by Ibach73dart

Update: I connected the black wire together using a new bullet connector for now and everything works!!! I’m done for now and thank you for all of you guys help.

Yeah I’m going to remove all of that and the bullet connector broke up that’s why the wire came loose.

So I should just connect it directly to the other end wire? The bullet connector just broke and I can’t find it anywhere at the auto stores. I needed this one

Yeah a lot of wiring from the previous owner and it’s all over the place!

Thanks redfish! You are right, I found the problem there also. The black wire was loose and I shook on it and everything came on! And then it just felt out... I think I can take the pin out and reconnected? Or do you have any suggestions? Thank you for all your help!

Thanks Redfish! I will do more research and see if someone can rebuild the old one first and I will check the white plastic connector and I did forget to plug in the wiper connector at the back of the cluster. I did it so fast and sometime forget lol

It’s 1973 dart 318. After the connected the red wire to the black post and put the cluster back in and I realized I didn’t plug in the wiper plug. That’s was dumb of me and I tried and plug it in while the cluster was in and the wiper still doesn’t work. Unless I didn’t plugged it correctly. But...

Thank you! I was reading another post that you were helping him also. Yeah I’m gonna see if I can get another ammeter or an after market one. Any recommendations?

Thank you for a fast reply! Yeah both red and black wires are corroded and I’m gonna fix that. And if I get a new Ammeter like an aftermarket one I can just hook it to those two wires right since the board itself is just a support? I thought it was part of the board.

Is this burnt and would I need to replace the whole panel?

To make long story short, i had no power to the whole car, bought new battery and still no power and car won’t start. Read couple of treads about same situations and when I remove the cluster and connected the red ammeter wire to the black ammeter post and I have dome light and car started up...

hello guys, I'll looking for one window stopper for my passenger side. Below is the picture of the piece. If you know where to get one or have one laying around please PM me. Thanks Bach

I know and the belt is slightly off a little bit! And when I removed the bracket to painted, one said "ford" on it! I need a mopar style setup.

Sorry Bill, mine is a 73 dodge dart swinger with 318 4b set up. Its on the passenger side. I took the picture from behind to show the wires. i will take more pic after work. Below is my engine, forgot I had it on my phone.