Recent content by ihave67cuda

Team, I am looking for an Automatic Console for my 69 Dart. I do not need the plates on top, really need the plastic base and the hinge. Thanks, Dan

have a picture of the gas cap?

Thank you all, for your advice. It is much appreciated, informative, and helpful. I will post a current status as we work on fixing the issue later today.

MOPAR Collegues -- let me explain my challenge a little better. Our challenge was this: When the car was warmed up, at the halt, in gear (Forward or Reverse) she tended to stall. To avoid this, I would shift the car into neutral at intersections. After shifting the car into gear and as...

Hello, Synopsis: For the past two months I have been having an issue with idle/slow moving stalls and 'stutters' from the stop or slow movement. It only occured when HOT. I then replaced the distributor and the problem continued. Now, last week I bypassed the balast resistor and...

would you happen to have the dust cover?

would you happen to have the dust cover?

im interested, pm sent

i did receive paper work that explained the balancing and all the weighting. The cast crank was balanced with the piston assembly with an aftermarket harmonic balancer without counter weights. the torque converter (without counter weights) was not balanced when the crank, harmonic balancer...

ok, All this helps. It is a 340 cast crank. I have a stock harmonic balancer that reads "use with 340 cast crank only" that came off the engine when the rebuild started .....I had the engine shop balance the crank and parts with a harmonic balancer that is not stock and does not read...

Hello everyone, I am confused and have a problem. Hopefully you all can steer me in the right direction. I have a 340 that is currently being rebuilt. I have: -cast crank -harmonic balancer (no counter weights) -and a torque converter also without counter weights. THE ONLY PART I CAN...

Nice solid find!

well 1. they are screwed in 2. they are overlapping I had to use some sliding and pulling the large piece under the rear window needs to be pushed up and forward (toward the front of the car) Did you take off any of the stainless trim? if not that needs to be taken off as well...

which side panels are you refering to?

I am selling a pair of 360 Cast Iron Heads, aftermarket cam and stock intake manifold. (all parts came off a 340) Follow the link for pictures and prices. http://tampa.craigslist.org/hil/pts/1902895348.html