Recent content by Inspector71

Hoosierdaddy: If you've had no problems, I'd say you have found a great solution. I managed to get my to fit but, considering all I went through, and how many heater cores I ended up with, I'll bet your solution is more cost effective as well. I salute you!

Pictures from other members' posts show it clamped on the rubber sheath so, wish me luck. I really am going to try and combine all the relative posts/threads into a Word document. I hope you all realize how hard it is to find this info. Outside of the forum, it may not exist.

Oh no. Another problem. Mine were all clamped on the cable. It's supposed to go on that metal sheath? If so, I'm done. I've been working on this box almost 2 months and it's holding up everything else. If it does not have those metal sheaths, does that mean I need new cables? It may have to go...

That is a really big help. Great pics. No screws means I have to confess to trying for an hour to snap it on and failed. I remember popping them off with a screw driver but no luck snapping them back on. I kept thinking, there is either a trick to this I'm missing or...I suck. Guess ai know the...

Not my box as I'm trying to understand which cable goes where.

I pulled these pics from another thread on cables but don't see a small screw. My bad eyes?

Thanks. I spent half a day trying to put back the restored box and was stymied by these clamps. They had no screws. On the bright side, I see washers with pointed stars hold the cable end on the actuator rod. The ones I pulled off are ruined so I would have needed these anyway. Back to Ace...

That is one clip, front and back view. There are 3 cables, 3 mounting brackets, and 3 clips. There were no screws. Hope this helps. When this is done, I'm going to try and copy all the posts on heater boxes, cables, heater cores, fiber glass repair, into Word and make a mini-book. You all have...

Thanks for the reply. The pics did not post thanks for the help. There are no halves, only a flexible clamp that I popped off, 4 years ago, with a screw driver. There were no screws either. If I can get the pics to post...

The picture is from the Plymouth 1968 Shop Manual, which is identical to the picture in my 66' manual. My heater box has 2, not one hole and 2 separate flex tubes going to defrost vents not one splitting into 2 as in the book. The clip bracket on my box is to the right, not left as in the...

Pics to be loaded

With all the pics on this site, I just might figure out which cable goes to which actuator rod. My 68' shop manual shows the defrost cable bracket to the left of the dual vent tubes, mine is on the right facing the box in the same direction. For now, my question is, how to pop the cable clamps...

If I didn't have stumble bum hands, ha ha. Thanks for the compliment. I'm a first timer at all of this. I miss the days when Darts, Dusters, Barracudas were commonly seen on the streets, not barn finds