ir3333's latest activity
-
ir3333 replied to the thread [WANTED] looking for a certain 440 exhaust manifold.does anybody know the part number on the 440 c body manifolds that may fit? -
ir3333 replied to the thread Raised white letters or blackwall.There is no preferred. You will see every conceivable combination so please yourself.
-
ir3333 replied to the thread What coil and wires to use..yup... 8mm wires won't fit. I've had good luck with standard 7mm auto part store pieces.
-
ir3333 replied to the thread NOT A PAINTER.what don't you guys like about self etch primer? Isn't it for tiny exposed bare metal spots before basecoat or sealer? I have never had...
-
ir3333 replied to the thread NOT A PAINTER.a long time ago i sand blasted a pair of original valve covers to restore and sell. After thinking about whether or not some sand was...
-
ir3333 replied to the thread Big Block Exhaust Manifold Comparison?.It's too bad that we only had Corinthian leather for a short time!
-
ir3333 replied to the thread Big Block Exhaust Manifold Comparison?.I think Rusty is correct...there won't be any difference. Those ratings were all over the place depending on marketing, sales and model...
-
ir3333 replied to the thread Rocker clips ???.actually i have both styles. 18 of the more rounded style and 17 of the other
-
-
ir3333 replied to the thread Rocker clips ???....i am pretty sure i have these clips somewhere. I have had these a long time and will see if i can find them. I know...a very old...
-
ir3333 replied to the thread TTI Exhaust.Mine was a lo compression 73 cast crank 340.1.88 intakes and a small .204/.214 duration cam. stock 2 1/4" exhaust to silent 22" mufflers...
-
ir3333 replied to the thread TTI Exhaust.nice numbers for 3.23 gears...what were your engine specs? My 340 was very low on hp and actually ran 14.05 at 98.5. Much faster than it...
-
ir3333 replied to the thread TTI Exhaust.Interesting...look a little closer, around 4000 they are the same and below 3500 the 2.5" has higher hp and torque! My last 340 shifted...
-
ir3333 replied to the thread TTI Exhaust.Rusty, Did you get up on the wrong side of the bed? Lots of enthusiasts read these posts...manifold down pipe info may benefit another...
-
ir3333 replied to the thread TTI Exhaust.I think the original drivers' side down pipe may have been 1 3/4" and probably won't make a difference on the street?
-
ir3333 replied to the thread TTI Exhaust.If you are under 400 hp the stock 2 1/4" exhaust is fine and leaves lots of wiggle room. ...but you didn't want to hear that.
