Ironmike's latest activity

  • I
    Ironmike replied to the thread Timing.
    MSD distrib. Also, the 3 -4 degree retard I posted about was using an MSD timing light. Using my old Craftsman dial back, I got 5...
  • I
    Ironmike replied to the thread Timing.
    Makes sense, Rusty. I was LEANING that way, but I think I needed to hear it from someone else. Thanks, brutha!
  • I
    Ironmike posted the thread Timing in Small Block Mopar Engine.
    Well , I remember reading here someone said ALL ignition boxes retard timing at higher RPM. Didn't pay much attention to it, but maybe...
  • I
    Ironmike replied to the thread Electric fuel pump failure. Recommendation?.
    This^^^^
  • I
    Ironmike replied to the thread Clutch thoughts....
    I've always heard those twin discs are instant lock up. Not what you'd want. That's just what I've heard........ I think what you have...
  • I
    Ironmike replied to the thread Trick Flows Make 600hp.
    Not OOTB. IMO.
  • I
    Ironmike replied to the thread Miloon Drive.
    I'm not going to do it, but I think that gear had another summer left....................maybe.
  • I
    Ironmike replied to the thread Miloon Drive.
    That's a Comp gear, by the way. Far as Cryo goes, I've had several competition rifle barrels done and the dude I deal with told me once...
  • I
    Ironmike replied to the thread Miloon Drive.
    Oh .....it will get replaced.
  • I
    Ironmike replied to the thread Miloon Drive.
    here's a couple shot of my gear I just pulled this morning. Don't mind the buggering up on the stem portion. That's from yanking it off...
    • g1.jpg
    • g2.jpg
  • I
    Ironmike replied to the thread Miloon Drive.
    Something definitely wrong here. Abnormal wear. Who's your engine builder?
  • I
    Ironmike replied to the thread Miloon Drive.
    That's exactly the shaft in there now. That long taper just seems much stronger that the immediate taper of the milodon unit. I guess...
  • I
    Ironmike replied to the thread Miloon Drive.
    never used any thrust button on any roller engine I've built. NEVER. I've got one out there with 500ish 1/4 mile passes and another with...
  • I
    Ironmike replied to the thread Miloon Drive.
  • I
    Ironmike replied to the thread Miloon Drive.
    So........ back to my original post. Would you trust this Milodon unit with 600+ horsepower?
Show older items
Back
Top Bottom