Recent content by jamesc

ok i have to ask a somewhat embarrassing question that i should know the answer to what is the interchangeability of dart doors? i'm under the impression 67-72 are basically the same. thanks

Not that versed in stock parts and think i have seen a couple different versions of these they measure 3 5/8" center of mounting hole to flat surface. glass beaded, painted satin black includes mounting bolts. $125 shipped continental US, located in south jersey, paypal absorbs fees

sold pending payment

sold pending payment

to those that have replied the brakes are sold. i sincerely apologize to superdart426 as he informed me that on this site a reply to the thread is the person with first shot however i was contacted by another member via PM and have committed to sell them to him. again i apologize as i was not...

73 up large ball joint, 11.75" brakes. all NEW Canadian ribbed rotors, NEW USA Timken bearings/seals, new pads, caliper brackets, dust shields, spindles, UCAs and LCAs. no chinese junk here. $375 PM here can deliver to carlisle saturday if paid for located south jersey

you can either buy good rockers now...or later after the cheap ones fail

new summit BB cam .465"/.488"-224°/234° @ .050, grooved for full time rocker oiling. $50 can delever to carlisle saturday if paid for PM here located south jersey

new General Kenetics .480/.480-230°/230° @ .050 single bolt hydraulic camshaft, grooved for full time rocker oiling. $60 can deliver to carlisle saturday if paid for PM here located south jersey

carter strip super pump new with gasket and factory attaching bolts. $70 plus shipping, paypal absorbs fees. PM here can deliver to carlisle saturday if paid for located south jersey

MP 5249150 stock (.890") diameter 383 torsion bars, installed in car never had an engine sitting on them. $200 can deliver to carlsile saturday if paid for located in south jersey PM here

yea long story but i was building a mild BB street dart. i'd also been wanting a mild door car to bracket race but drove all over the freaking country looking at junk so i decided to use the car i was going to make a street car. i hate to sell all the stuff but i'm not using it. i had basically...

sorry forgot to mention location parts are in southern new jersey

sorry forgot to mention location parts are in southern new jersey

sway bar with brackets, reinforced LCA with new moog bushings and poly bushings on sway bar ends. $250 possible delivery to carlisle PM here