Recent content by jgmccrac

If you have an EGR valve, is it recommended to leave that blocked with this setup.

Sorry to resurrect an old thread, but in using a Jeep style starter relay, is the extra IGN terminal mentioned above powered in both start and run? I am assuming I can use that additional terminal to power my EFI during start and run?

Did you mount your heater control valve under the dash?

I think I figured out my issue. The caliper on the drivers side when installed on the bracket were touching on the top of the ears of the inboard pad, causing it to rock and to not fully seat on the bracket "ways". When I compared it to the passenger side, the ears on the inboard pad were not...

Will post pics tomorrow. I am running the 10.97" disc brake setup from a 73 Duster.

I have tried two different ones from two different suppliers. I also had the suspension checked as well.

I have an issue with a braking problem. The car pulls mildly left. I have replaced flexible hoses, calipers, and pads (on both sides, even though I know the issue is supposed to be on the passenger side). While changing the calipers, I noticed the drivers side rotor was very difficult to...

Looking for a 67 Steering Column for a floor shift power steering car. Let me know what you have. Looking to get one shipped to zip code 30328. J

Thanks. No worry. These 293 gears are rare it seems.

Any luck?

Thanks. I appreciate it. I am still looking for a set.

Appreciate the clarification....I am sure I am not the first, but thanks all the same

If it is in good shape, I am interested. Let me know also what you want for it. I would need it shipped to zip code 30328.

Looking for a 294 Ring and Pinion gear for a 489 case

I am in Atlanta.