Recent content by Jim E

Hood insulation, rear seals, front bearing seals. Packed the bearings on the front and put the disc back in place and the studs turn when I tighten the lugs, dammit. can't find front rotors for it!

Thank y'all for the input and the spec,s, will get into the tear down soon. Let ya know what I find !

Do you have the dog bone bracket and hardware with it?

Need to install a new clutch and pressure plate. Have a leaky seal on gear box. Haven't pulled apart yet cause I thought it would be nice to have replacement parts ready to install. Looking up what is available I am not sure of the size clutch I need. They show 10.5", 10.95", 11". Do any of the...

While I have to wait, calipers have to go on the F 250 and diff joints. The Cobra missed the show cause the fuel reg decided to take a dump 2 hours before hand. Sometimes it just happens.

Front suspension rebuild kit, front rotors, rear drums. damn glad I have a lift lol

I thank y'all for this information. I do have a wiring diagram but will check in on that manual ya suggested. Looks like I will have to remove the panel to make sure all is done. Purchased this a few months ago and thought this would be a good investment to join FABO, APPRECIATE the help!

'69 Dart instrument panel not lighting up. Looking up behind drivers side left in a clamp I see [ for lack of better knowledge} what looks like a condenser for points. This has a short black wire with a flat male connector. Any advise or experience in this area?