Recent content by Jim Ward

I have a good upholstery guy in the Grand Rapids area. If you’re willing to drive a few hours Pm me and I’ll provide his contact info.

Pending on FEBO.

Possible meet up in the Detroit area or Chicago area as I travel for work quite frequently. These heads are bolt on ready.

Payment sent. Thanks Jim

I’ll take it. Pm incoming.

A pair of 2.02 J heads for small block Mopar. Heads have less than 300 miles on them set up for hydraulic flat tappet cam up to .525 lift. Cast dates in photos one July 1969 one November. Can provide a video of the heads running on a 360 and ran excellent. Shipping is available but expensive...

I just have these.

I have them. How many do you need?

@Dusteroldschool

A direct connection a body big block k frame that has had the welds corrected and rear lip removed for oil pan clearance. Clean k frame $500 plus any shipping or pick up near Grand Rapids MI or can deliver this weekend between GR and north east Ohio.

I will be traveling down 80-90 from Grand Rapids Michigan to Streetsboro Ohio Saturday 1/3 and can meet anyone interested along the way with these heads.

Need a passenger side rear tail light for a 1968 Plymouth Barracuda fastback. Located in Michigan. Driver quality is ok but would prefer nice and to match close to the drivers side.

Sorry Bob I can’t sell these heads and rockers for $500. I’m not going to give the rocker arms away. Good luck with your search. I just had a set of U heads completely built by my local machine shop and the bill was almost $1200.

$500 just for the heads. I never had them checked. They were on a motor I bought. They are fresh rebuilt and never ran. I put aluminum heads on my motor. I am traveling to Ohio in the next week.

The moroso set from Amazon or summit has the correct hole for the centering pin. These are the only perches I buy. Merry Christmas FABO Family.