Recent content by jim whelan

Converting a 67 a body convertible fish from inland to hurst I need the bracket that mounts to 4 speed. I purchased the hurst conversion shifter from brewers that utilizes the inland console handle. Looking for the plate that goes between the hurst shifter and the tranny tail piece mounts with...

Looking for the hurst mounting bracket and hardware to trans.

Interested if still available

Got car with a 360, changed a broken mount new mounts look out of position and stressed. I know the 273 mounts don’t work on a 360 how can I tell if I have the 273-318 mounts on this 360? Ty

Is the hurst shifter with linkage and mounting plate available in on Long Island would be interested in some other items brakes trim ty

Interested but shipping to 11771 will probably kill any deal

Do you have the shifter, linkage and mounting plate to go with. Ty

Tyvm thought I could maybe get away with it

My question is are the three linkage rods the same or do I need to swap them as well ty. The cable for the reverse lock out on my inland is getting very sloppy

Ok yes, I got that now I should have measured the stroke as well. I’m just another example of why you shouldn’t rush, live and learn, it runs and cruises just feels bogged down like I’m pulling a boat and when I tune for better bottom end it falls apart at the top cruising off load slight...

Yes, thanks for pointing out my mistake hope you feel better

Thank you, is this measurable thru the plug hole ? Possibly? And would that change the cam set up?

Agreed, and that’s part of the reason for the thread. Because if I’m giving up on this cam I want to verify a new cam is better suited to the mechanicals, do they run different cams for stroked engines? The cam I got it with was a Hughes seh2428AL-11

Edelbrock Avs 2 650 323s stock intake x heads automatic 2400 TQ, MP electronic ignition

My 1969 340 is 40 over, when I pulled the motor to freshen up the cylinders still had a fresh hone so I just did the heads over new gaskets painted and back in, but I did go with a new comp cam xe268h lifters rods and rockers. I just lined up the dots no dial in. Without taking the engine to far...