Recent content by JimD

where is the best place to buy brake hoses, I understand that the copper gasket may be aproblem in some hoses, thanks Jim.

can I use one of the new small wireless speakers for my ipod, in My 63 Dart, instead of the more expensive speakers(aka) underseat, thanks Jim.

My neightbor has a big bolt rear with the regular yoke, what else would I need to swap from the ball & trunion, thanks Jim.

Just installed a dual mc on my 63 Dart, looking underneath the rubber brake hoses are starting to split. I'm going to replace all the lines , and hoses . Can anyone recommend where to get them, thanks Jim

I bought a dual master cylinder from rock auto raybestos mc 36221. What do I do with the plunge rod, do I take the insert on the new mc out, and replace with the old , or do I have to get a new rod, I'm stuck help, thanks Jim.

I need to replace the whiskers, do you have to take the glass out? Can anyone give me tip on how to do , its a convertible, thanks Jim

how about instrument cluster, Jim.

What wires and plugs are you guys using, also rotor cap, thanks Jim.

how much for the dash pieces, including the guage console, also do you have a steering wheel, and what kind of shape is it in, Jim.

I did a compression test, all cylinders 115 Lbs, also put a vacuum guage on,steady as a rock. My brother said maybe a bad dist. cap I did get bit by one of the wires I tried to take off while running, so may get new wires, any other suggestions, Jim.

to do the poor man's test , do you have to have the plugs out, I had the valves adjusted after it started missing, didn't do any good. The car runs good while driving, its just at idle, thanks for all the input, Jim

I thought it was my ignition was causing a miss, well after chasing it down for a week, my neightbor came over , another slant 6 guy. we pulled the plug wires off 1 at a time, and # 1 didn't change. Put on a new plug wire, still the same. Neightbor says maybe head or piston skirt, Will do a...

I'm sorry my petronix is the original not the 11, does that make a difference Jim.

I installed a petronix 11 in my 63 Dart. was running fine for a while,but started to miss . I have all new ign parts except the coil. I bypassed the ballast resister, hooking the 2 wires together, miss is gone.. Do I need the ballast resister, thanks Jim.

Has anyone made there own tool for removing the front bezel of the key ignition, they are $20. on ebay, thanks Jim.