Recent content by John K

  1. John K

    Axle Swap to upgrade to a 4.5" BP

    No, disc brakes are fine. The only change I made was the speedo gear because the ratio changes slightly.
  2. John K

    [FOR SALE] 1970 Duster 340 4-Speed

    I've tried contacting you twice. I believe you need to empty your inbox so that you can receive my messages.
  3. John K

    Responding to your request for PM. Tried messaging you but your inbox is full. You need to empty...

    Responding to your request for PM. Tried messaging you but your inbox is full. You need to empty it to receive further messages.
  4. John K

    [FOR SALE] 1970 Duster 340 4-Speed

    I am selling a 1970 numbers matching H code Plymouth Duster with original 340 motor, manual A833 4-speed trans, 8 3/4 sure-grip rear end with 3:55 gears. It comes with two hoods, two sets of wheels and tires, two air filter housings, and the original exhaust manifolds. It is triple black, with a...
  5. John K

    [FOR SALE] 1970 Duster 340 Matching Numbers H code

    It was originally gold.
  6. John K

    [FOR SALE] 1970 Duster 340 Matching Numbers H code

    I am considering selling my 1970 numbers matching H code Duster with original 340 motor, manual A833 4speed trans., 8 3/4 sure-grip rear end with 3:55 gears. It is triple black, with a black interior, black exterior, and a black vinyl top. It has a Ralley dash, electronic ignition, mild cam, new...
  7. John K

    M-1 Intake Manifold

    Thanks, this is the manifold I see available, but not the 891. According to some on this thread, it's not one of the two that will fit my car. I assume it's because the bolt spacing is different. Thanks for the follow up.
  8. John K

    M1 Air-Gap Intake Manifold for a 340 motor

    Wow, you're right. My apologies, must be a senior moment.
  9. John K

    M-1 Intake Manifold

    Do you have a part number or casting number for that M1 manifold. I'm looking to put an M1 on my 340 LA heads but can't get an accurate part number or casting number. Thanks
  10. John K

    M1 Air-Gap Intake Manifold for a 340 motor

    I know this topic weaves through a lot of forums, but I've spent hours looking for a definitive answer and had no luck. I have a 1970 Duster with a 340 and have been looking for an M1 Single Plane Air-Gap intake manifold to put on it. The problem is that I don't know the proper part...
  11. John K

    70 Duster Exterior Question

    That makes sense, nothing is ever straight or lines up exactly. I will be sure to get some Rapid Tack. Thanks again for your help.
  12. John K

    70 Duster Exterior Question

    Thanks Jim, I'm not quite ready to apply the stripe kit, but I may take you up on your phone call offer. Did you put the stripe on the body line, or maybe an 1/8-3/16" below it? Thx
  13. John K

    70 Duster Exterior Question

    Do you know of the proper guidelines for where to apply that side stripe? How far below the body line does it sit? Start from the back and go forward, start in the middle and work outward? Any help would be appreciated. I have the same stripe to apply and can't find any direction. I prefer not...
  14. John K

    Center Caps for 4 lug Centerlines

    Thanks for the heads up
Back
Top