Recent content by Johnlow151

Thank you, that was very helpful!!

So you think I can get 400 horse out of the stock magnum heads?

I heard that the stock magnum 360 heads flow pretty well too. Is there any point in having those ported or are they junk?

Well the point of making the 450 horse is to make it something special for the most part, and some nice tire shredding power. I do think I might go with the w2 heads, can anyone recommend and parts for the rest of the motor? Pistons, cam and springs?

I’m looking for a fairly decent cam, at least 500 lift. And I was trying to decide between w2 and edelbrock performer rpm heads

I’m mainly using it to drive street, but i want to be able to do some 1/4 mile for fun. I’ve already built a 727 torquflite and have built a 318 and a bunch of small block chevys so I have some experience building motors. I would rather build my motor than buy a crate engine because it’s fun to...

I am building my 1970 Duster from the ground up and am looking for help on the engine, I want to build a 360 magnum for around 450 horsepower. I plan on keeping it on pump gas and want to keep it for street use primarily. Looking to throw a carb on it as well. Any suggestions for which route I...