Recent content by Just-a-car

Hi, thanks! I snarfed up 2prs. Anco 42-03 adapters that seem to be the ones used for the 41-03 arms for our cars of discussion. !! fingers crossed, of course. Also had to buy a pair of these as the splines here too are smeared. 1960-1962 Plymouth Dodge A-Body Windshield Wiper Pivot Assembly...

Thank you!

Hello, again! I cannot find a part number or listing in the MoPar Passenger Car Parts Catalog "R2 Series 1961 for the windshield wiper arm drive bushings. I'm thinking my sense of terminology is out of kilter with MoPar-ese. Therefore no ability to find them through our now merely half *** smart...

go-fish, Have you any idea if the much mentioned 4Runner Denso alternator will fit on my 1961 170 cid Valiant, and would the out of the box single groove pulley be the correct size? What Denso pn. should I be looking for? Searching about my local Autozone seems always to have in stock a Duralast...

Very true Thank you.

Indeed poor machining concentricity mucks the works in compounding ways. Thank you, again.

YES!!! I had forgotten about the VR-128 regulator. I'm fairly sure there are a couple new in the boxes on the shelf in the hangar where my old hands still wrench bend sometimes. MSD: Also sadly so very true, but of course our mfg. management made the decisions based on kick back bonus schemes...

slantsixdan, Thank you. The car is drive-able now (just bought it from a consignment dealer in New York ostensibly listed as genuine 15,000 mile car. Well, we both know that was a hoax however still a good clean car. The alternator bearings are shot. Plus I detest solenoid type voltage...

Hello. Newbie to this forum and A body MoPars, thus this will very likely read as a dumb and dumber query to the cognoscenti here. However the experienced advice is where we all learn (or perhaps 'learn to learn with and from'), therefore I will hazard my ignorant question. Are there one wire...