Recent content by kbsouers

Jbc426. Thank you. Tig or mig is no problem. I like how your seat is incorporated. I now need to consider weather or not to have a back seat or just a large flat deck.... Hmm...

Thank you everyone. You all have good thoughts. Got me thinking now.......I'm going to price out a pipe bender I've always wanted and tube from a local steel supplier in 20foot lengths. Plus a hole saw jig for the drill press. I think I can tool up for what I would pay for a 8 or 10 point...

I am at a point I need to decide on safety restraints. I would like t use 5 point harness. In purple to match the car. I need to install a roll bar to mount the harness to. Jeggs seems to be priced the best. Does anyone have suggestions . I am a little concerned about having to climb over the...

Sorry everyone, in my hast... I neglected to pull out my old fender pieces. I would have quickly Seen that both buckets are "left hand buckets" this works because both left and right horizontal Adjusters are located on the left side of both sealed beams.:color: I was too focused on...

I'm looking for a right side headlight bucket and chrome trim/retaining ring for my 1968 barracuda. I have two left ones. my rt light was mounted sideways as a result .😝 If you have a set I will take both. I would buy a remanufactured one I can't find any. If anyone knows what other...

It's alive Sorry Video did not upload??? I'll work on it this evening

The pics don't show it. I'm useing a radiator cap with a air pump and a pressure gauge attached to it, to pressurize the system. ( I hate to fill a system and hope?!?!...)

Hooray my drive shaft came a day early.:blob:

You can see the soap bubbling up on the back side of the bracket

cking for coolant leaks before filling the system. I used soapy water around the different fittings which showed three leaks . Got two of them sealed but the third one on the alternator bracket to the water pump .the long bolt will not seal easily for me . The bolt only goes in about a...

:coffee2:

222

111

I still need to fasten it in A few places

New line..