Hey FABO
so this past weekend I went to install a transmission mount on my 66 barracuda and while doing so by dropping the tranny a bit I managed to mess up my throttle linkage a bit. Its now very hard to accelerate but I looked and the linkage now goes into the firewall at an angle and the...
So far the stock heads and all I know about the cam is that its a 218/224 Competition cam. Bought the motor from a donor car that had the cam in it already
Had the same issue when I swapped my 360 into my barracuda. Went through 3 voltage regulators until I changed the ballast resistor and the ballast resistor fixed my issue. Just another idea for you to try.
hey guys
I am running a 360 in my 66 barracuda and am trying to find out a good timing setup to run. The engine has a 218/224 cam, 670 cfm holley carb, RPM Air Gap intake and MSD 6AL box, with the stock distributor. Right now if my memory is correct my timing was right around 8 degrees. But...
Ok I feel like an idiot asking this question but I recently got a prothane trans mount to use in my 66 barracuda but the only mount that I can find is the crossmember. Is there another mount that I'm not seeing. Transmission is a 727 connected to a 360