Recent content by Leeroy

Some of you guys may have already seen this but here's a good reason to be thorough and do things right when building a car. The poor guy just bought the car , pretty sure he wasn't expecting this ! http://www.cbc.ca/news/canada/edmonton/stony-plain-muscle-car-loses-back-axle-1.3082209

I just replaced all 4 on my Duster , cost $3.15 each from our local Dodge parts. If your going to replace all of them pull the linkage arms right out from under the dash , way easier to get them in the ends of the arms on a bench. You can finish pressing them onto the pins with a pair of...

Ok , I have a reverse switch on the trans that works , wires from the switch are Blk/Blk trace running up to engine bay , have a T shaped plug . Under the hood the only plug that matches on the harness I plugged into lights up the EGR lamp on the dash when the car is put in reverse , kinda tells...

My apologies gentlemen , I referred to 5 x 4.25 when I should have been talking about 5 x 4.5 on the front of this car. Front brakes went on no problem , rears today after getting proper shoes and cylinders late yesterday.

I am having trouble with the reverse lights , found the wires tied up around the speedo cable by the previous owner. The two wire lead goes from a round contact plug on the tranny (4 spd standard) to where ? I have no idea where this goes , it has a black plug that I can get up into the engine...

So looks like the diff has been changed out , thanks guys. Now I need to find out if the axles I can get with 5x4-1/4 hubs will fit this diff.? Would like to eventually end up with the same bolt pattern front and rear.

Hey guys , doing the brakes on the 75 Duster . Ordered parts and as per usual you never end up with what you thought you bought. Turns out the diff has been changed out , I have 5 x 4-1/4 on the fronts so the new disc fit the wheels . Rear is a different thing . Ended up with drums and shoes...

Furious65 , thanks for the link . Great info , I did a couple searches but this didn't show up. All things considered I will probably go with Hedman's shorties .

Hey guys I'm considering Hedman's tight tube shorty headers on my 75 Duster 360 4spd. Just picked this car up recently and knew it was needing work , lower tubes have basically been flattened out real good . Car has power steering and I'm wondering about the collector being an issue. I know...

Thanks , it's going on the stands tomorrow and I get under the dash also.

Thanks guys , I'll do some chatting.

Hey guys , Just getting started on a project after being out of this stuff for a while and need a bit of info. I'm looking for the neutral switch and the reverse light switch on a 75 - 360 ,4 spd Duster. The Haynes manual is good but doesn't give me locations on these two switches. The guy I...