Recent content by LETSRACE

I have remote oil filters, the accusump is piped into the output side of the oil filter.

Looking to sell my Holly six pack setup complete with nitrous plates, bottle heater, purge solenoid, hose, pressure switches, chrome air cleaner and Edelbrock LD6B intake manifold. Carbs are manual secondary and fuel inlets are on driver side. Located in Plainfield , Illinois 60585. Shipping...

2x Bob at Pro Glass

I have it set up so before every start the electric valve opens and pre oils the motor.

Agree, I had a hard time finding the flex plate to put a Reid Race Glide on my small block. TCI had what was needed.

I used a S & W Back half kit with a 4 link. I will say with about 30 runs in the books with this setup its so consistent its scarry

Sale Pending

Yes too much to list, if you send e-mail I will send more pictures. Thanks Frank

Looking to make some room in the shop, all must go at the same time, local pick up only. Located in Plainfield, Illinois just west of Chicago. $100.00 for the lot.

Call Kevko 800-770-3557, its a small mom and pop shop that answers the phone and has a great product. part number is M301a for the stock sump location $735.00

408 LA, Indy 360-1 heads with Fierra valves, n/a tall fill block, Hughes main bearing girdle, Ross coated pistons @ about 13.0 to 1, Moroso vacuum pump, Eagle crank and rods, kevko rear sump aluminum oil pan, T&D rockers, TTI 1.7/8" headers, XS 16 volt agm battery, MSD 6al ignition, 2 speed...

I have a hood and windshield from a 72 Duster near Chicago