Hello, I'm looking for 2 driveshafts for a 74 duster. I'm either doing a 318 with a 904 OR BB with 727 but want both options available. thanks!
904 to 8 3/4
727 to 8 3/4
located in central ks.
Some cats can handle being outside. I see them look both ways before crossing roads even. Other cats just run and hope and that's how you get killed. Cars aside, I hear coyotes howling every night and we get hawks and the damn neighbor dogs. My cats are my emotional healers so I give them...
74 duster with RV2 compressor. I'd just like the bits between the condenser and the firewall, minus the compressor. Thanks!
shipped to 67502 and I need them in time for Hot rod power tour :)
We have a dog that shows up once in a great while. seems to raise hell through the neighborhood whenever it does. Last time he showed up with a buddy and was very aggressive. You can tell when a dog is ready to attack vs if he is just growling and showing teeth - frightened the **** out of me...
Good morning, There's a couple of things to unpack here. the car - 74 duster.
First is when I was putting my car back together after paint, on the drivers side, the lower hinge pin was wayyy too small for the hinge (bought a new pin kit) This tells me the door hinge was probably from something...
Do you think for a shop floor that mesh will be enough?? it's been an ongoing debate in my head. heaviest thing that'll be on it will be my 3/4 ton truck
For a pole barn you can save the concrete till last. I'll be doing it myself for a 36 x 50. planning on doing it in sections so the truck can get to it without a pump. I'm estimating $3500 for ~5" and then about $1500 in rebar.
yeah those intake manifolds are REALLY easy to remove... A little trickier on the RWD applications, but once you know how to fenagle the intake around it's not bad. However it looks like the OP's method worked well too.
It gets faster with engine speed. flex plate bolt? something on the accessory drive loose? I think the next question is "where does it sound like it's coming from?".