Recent content by Lord Sparky

  1. Lord Sparky

    Did anybody saw this important video of Joe Zolper

    When my dad died we rented three huge dumpsters and and spent two weeks throwing all his **** in them. He did the same thing with his mom.
  2. Lord Sparky

    The Modern Dodge Dart Wasn't A Bullseye But Owners Seem To Love It Anyway Read More: https://www.jalopnik.com/1949976/modern-dodge-dart-following/

    The Modern Dodge Dart Wasn't A Bullseye But Owners Seem To Love It Anyway - Jalopnik
  3. Lord Sparky

    Odometer reading after restoration

    I set mine to original.
  4. Lord Sparky

    1969 Dodge Dart GTS—Fuel Filler Neck

    Dano says you don’t have to drop the tank to get the tube inserted but you’re saying you have to lower the tank?
  5. Lord Sparky

    1969 Dodge Dart GTS—Fuel Filler Neck

    Can the fuel filler neck/gasket be replaced with new ones from inside the trunk without unstrapping/dropping the fuel tank?
  6. Lord Sparky

    Duster TV show

    He’s been lost since Lost.
  7. Lord Sparky

    1968 Dart Convertible speaker ideas.

    Remove radio, listen to the engine and wind.
  8. Lord Sparky

    M code dart

    Welcome to the club!
  9. Lord Sparky

    440 Engine tuning suggestions

    I live in Southern CA and add 3 gals 100 octane to the 91 octane per fill.
  10. Lord Sparky

    1969 Dodge Dart GTS: How to remove rear exhaust hanger to replace

    All done! Used a jig saw to cut off the bolt. A little tricky getting the new bolt in with my fat fingers but I persevered. Thanks for all your suggestions!
  11. Lord Sparky

    1969 Dodge Dart GTS: How to remove rear exhaust hanger to replace

    Yeah, I lay in bed thinking about that but alas the hole was too small.
  12. Lord Sparky

    1969 Dodge Dart GTS: How to remove rear exhaust hanger to replace

    Used a jig saw to cut it off. Where and how was the original hanger mounted?
  13. Lord Sparky

    1969 Dodge Dart GTS: How to remove rear exhaust hanger to replace

    What kind of tool can I get through the frame holes to grip the 1/2” bolt (the rubber exhaust hanger right before the exhaust tip hanger) to keep it from spinning to get the nut off? There is an access hole in the trunk but it is not directly over the bolt.
Back
Top Bottom