Recent content by LP1966

Photo from above

Thanks Dana Dart. Seek and you shall find left hand thread lug nuts. I'm going to buy these (photo) and see if they work. I checked again with Mega and they say these are the right ones. And yes, the lug nuts go one first, the the caps. Thanks again.

Hi Folks, Thanks again for the replies. There continues to be a mystery about these...now it's the lug nuts themselves. These are the chrome lug nuts that stick through the holes in the hubcaps. (see photo). I spoke with Mega Parts and asked what length theirs were, or if they had a spec sheet...

Again, thank you.

SWEET! There's a lot of sweat in that kinda work. Thanks for the photos.

Also, where's the best place to buy 20 chrome lug nuts for these hubcaps. Still learning about this car...one one the nuts tighten clockwise, the other side counterclockwise. When I questioned that, I was told "Welcome to Mopar!"

Much obliged, everyone.

Me and the Cuda say Thanks!

Hi folks. I have a 66 Cuda with 14" wheels. I've found the correct hubcaps for a 67 cuda w 14" wheels. Is the lug spacing that same for these 2 years? I have a chance to buy the 67 hubcaps with the 5 holes for the lugs to stick through, but I haven't found any lug spacing dimension for either...

Hey Rick Layson, Which foam on http://www.joann.com would work best for the rear seat padding on a 66 Cuda? I looked at Item # 11178100, Item # 13136163, or something different? Thanks

67Dart273 - good luck with the 67 renewal...that's a lot of work. keep us posted.

OK, so I rebuilt and then re-rebuilt my old AC control switch...each time something different would not work. Out of frustration, I bought this switch http://www.ebay.com/itm/160642617456?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649 I had to wire the 3 terminals differently, but it works...

update: I installed the repaired switch. Everything worked find until I pushed the Defrost button, and the door would not move from Heat position. It goes from AC, to Max AC to Heat, but no Defrost. Hmmmm... I think that when I drilled that one hole all the way thru, thus making a really...

Thanks everyone. Here is what I've done so far: 1) removed the old switch and found 2 of the 7 pins on the vac connestor missing. 2) found an ink pen with a similar OD size ink barrel (the ones on the switch are .130", and I found an ink barrel with .125" OD) 3) drilled out where the pins were...

67 Dart, I dont have a vacuum test pump. I have heard about a vacuum tank - there is not one on this car but should there be? Also, does an inline, one-way vacuum valve help? KitCarlson, is the "vacuum connector" you speak of the 7 pin (a row of 4 and row of 3) one in this thread -...