Recent content by macs_wedge

  1. macs_wedge

    [WANTED] LA Block / Engine Wanted

    I have a 318 located in Brazil, In. call [Phone number removed by staff]
  2. macs_wedge

    72 Demon rust free Pro-Street project

    Yes my Demon is still available but it does not have a 5 speed, it has a race prepped 727 torqueflight. You may have my post confused with someone elses.
  3. macs_wedge

    72 Demon rust free Pro-Street project

    I have started installing a 440 engine and 727 trans into the demon. My plans have changed due to selling my bracket car. I will be getting the Demon ready to race this spring. As more of the work is completed; the price will be increasing. It is still for sale, but call for current price...
  4. macs_wedge

    72 Demon rust free Pro-Street project

    After getting under the Demon I discovered that the construction of the back half was not done very well and should be reworked. Due to this; I am reducing the price to $8000.00
  5. macs_wedge

    72 Demon rust free Pro-Street project

    rscott2560..I prefer to sell straight out, have too many projects. thanks for inquiring.
  6. macs_wedge

    67 Belvedere II, 2dr Hardtop for sale

    I'm located in Indiana about 45 miles west of Indianapolis. I'll post more pictures.
  7. macs_wedge

    67 Belvedere II, 2dr Hardtop for sale

    Great restoration project, Survivor car, I am the 3rd owner. 83,*** miles, 318 auto. Runs good, brakes good, Steering is firm. Has 8-3/4 sure grip with 3.55 gears. Known issues: Gas tank leaks but only when filled above half tank, gas gauge and dash lights not working. Lower quarters have rust...
  8. macs_wedge

    Duster Driver side Quarter Panel needed

    Looking for drivers side quarter panel or at least from the beltline (right below gas cap) down. 1972 duster, but other years should work. I'm in Indiana, but travel Ohio and Northern KY frequently.
  9. macs_wedge

    72 Demon rust free Pro-Street project

    Have attached more pictures.
  10. macs_wedge

    72 Demon rust free Pro-Street project

    I have a new set of 440 mopar chrome headers, big tubes 2" or 2-1/8" not sure. Cost over $500.00. It is set up for a big block. I did have a 440 in it, but took it out to use the heads on another engine. That short block is fresh with Speedpro pistons, .509 hyd, cam, lightened & balanced rods...
  11. macs_wedge

    72 Demon rust free Pro-Street project

    Nice 72 Demon. $8500.00 rolling on 8-3/4 with 3.92 sure grip. Factory bucket seats, console, shifter. Tubbed, Weld Prostars front and rear with new M/T tires. New fuel cell, new gages, new headliner. I have stock to wild big block and small block engine combos for additional $$ if needed...
  12. macs_wedge

    72 Duster - Bracket Car or Pro Street project

    Has been back halved. Sitting on an 8-3/4 single trac. Not finished. Needs LH Quarter panel, and RH lower fender extension. Doors close nicely, Glass is all there, Floors have only a few small rust spots. Comes with single racing seat. Set up for Big Block. No engine or trans in it now. I do...
  13. macs_wedge

    70-72 dart/demon fenders the same?

    There is a swap meet coming up at the marion co. fairgrounds...let me know if you need anything.
Back
Top