Malex's latest activity
-
I think it was more of a general question about the ‘68 S/S cars. They were not street cars so IMO they weren’t necessary. They likely... -
Malex replied to the thread transmission cooler placement.Not sure who the question is for. Myself though with an 8”’converter it’s a good addition for the 572. It’s nicely tucked away...
-
Malex replied to the thread transmission cooler placement.You’ve done a very nice job of the install. A lot of work went into your install.
-
Thanks. If you mount a cooler in the back there generally needs to be a fan on it. Having it in front usually provides enough airflow...
-
Malex replied to the thread transmission cooler placement.I thought about the rear but they run cooler up front and the rear was busy anyways. Nice set up though.
-
-
Malex replied to the thread transmission cooler placement.I’m not expecting any problems. It’s mounted the same as my B body cooler, which has been in use for coming on 9 years, including close...
-
-
Malex replied to the thread transmission cooler placement.I grabbed a couple of pictures for you. The 2 bolts circled secure an aluminum angle on the underside. Then the cooler bracket is...
-
-
hello, do you have anymore pictures of how this cooler is mounted, this is done extremely well and clean! thank you
-
Wow very clean! Yes it was making 1100 n/a and 1500 with nitrous.
-
Malex replied to the thread Not so much a clone Hemi Dart.That’s serious fast. Must be 1100+ HP. A beautiful 67. I put Stage V black covers on my KB, would like a little more bling though...
-
-
Yes all top end is Indy here. Material used to cast these valve covers is very porous, these valve covers look very nice but up close...
-
Malex replied to the thread Not so much a clone Hemi Dart.That’s moving it for sure to get that far in short time. A very nice set up. Another nice set of hemi valve covers. Got to get me a...
-
Yes I put the 605 back in the Coronet today and installing headers was a piece of cake! Took me 5 hrs to install trans, engine and bolt...
-
Malex replied to the thread Not so much a clone Hemi Dart.It’s a fun challenge to get a Hemi into an A body. Although you can use a torque wrench on every header bolt. TTI headers. Can’t do...
-
I always wondered how rough is life with Hemi in A-Body... I mean big block is not fun at all but I still am tempted to go Hemi in my...
