matthon's latest activity

  • matthon
    This will starve your engine at higher rpms with the dinky a-body big block pan. Better off without the windage tray.
  • matthon
    matthon replied to the thread Nova SS 396 sells for 250,000.
    Friend and I were just discussing this post from Lost Muscle Cars. I said if the Nova was an L78 it would be high on my list.
    • FB_IMG_1764712721181.jpg
  • matthon
    matthon replied to the thread PATINA.
    I threw a cap and wires on it, but no luck.
    • 20181112_161244.jpg
  • matthon
    matthon reacted to 1WildRT's post in the thread Data plate question with
    Agree
    Agree
    .
    Well... It was decoded as W11.... But while close it's not in the correct location to be a W code.... The codes are in alphabetical...
  • matthon
    matthon replied to the thread Data plate question.
    Post #17, is that not W11 in the upper left? I need a little help/advice
  • matthon
    Fastback glass has the stainless trim/seal on the door glass, notchback and conv have it on the rear side glass. Fastback and notchback...
  • matthon
    matthon replied to the thread 10" or 11" brakes?.
    I have KH up front, had the original sbp rear drum. When I upgraded to bbp in the rear I went with 11x2.5 drum brakes, just because...
  • matthon
    matthon reacted to dano's post in the thread EFI to replace Edelbrock carb with
    Agree
    Agree
    .
    This. I went all Sniper. I love it, works great for me. I can tune with a laptop. Car can sit for 4 months, turn the key, prime, fire...
  • matthon
    matthon reacted to mygasser's post in the thread 1971 Demon, FC7 Plum Crazy with
    Agree
    Agree
    .
    it's great to have a load of these jobs completed ready to be refitted later on :thumbsup:
  • matthon
    matthon reacted to 71GSSDemon's post in the thread 1971 Demon, FC7 Plum Crazy with
    Agree
    Agree
    .
    Don't be afraid to start putting your engine together on the kitchen table. Helps with motivation...its what I am doing while I am down...
  • matthon
    matthon reacted to tom999w's post in the thread 1971 Demon, FC7 Plum Crazy with
    Like
    Like
    .
    Thanks for the info. I was thinking what you said and decided to work on the things that can be done in the house too. So I started...
  • matthon
    Same scenario here. They replaced my pump twice. I only discovered it when I swapped it the second time. Drained a near full tank and...
  • matthon
    matthon reacted to jbc426's post in the thread Air Gap hood clearance with
    Like
    Like
    .
    I use a wad of aluminum foil on top of close clearance items to verify adequate clearance. I didn't have to run a drop base air cleaner...
  • matthon
    matthon replied to the thread 1971 Demon, FC7 Plum Crazy.
    I hear that, sucks. Winter in the northeast without a heated garage is a time to work in the house. For my 62, I sat on the floor, TV...
    • 20251024_174945.jpg
  • matthon
    Is the small section of hose in the tank rated to be submerged in modern fuel? There's a difference between efi hose and submersible...
Back
Top Bottom