Recent content by max512wedge

I know what you mean about cutting up the fenderwell. I’m on the fence about it. I’ll be making my decision here after I get the motor back from the dyno here in a few weeks.

Thanks I’ll give them a call.

I called Hedman earlier and the guy said they no longer make them.

What type of fender wall headers for a 72 duster running a stroke 440 with raised port Eldabrock Victor max wedge heads. I have some tti 2 inch headers I was going to use but I think I want to go an easier route than using them as the fit is very tight.

I know exactly what you mean. There’s a lot of highs and lows during a build. “But”! If there’s a next time I’m buying one done or almost done.

That looks clean. Beautiful car you got there!

I ended up getting the right ones from Mr Gasket part #7430G they fit perfectly.

I’m on vacation and not in town so I can’t measure them at this time. I did place the gaskets last week over the exhaust ports and the ports were significantly larger. I ended up getting the larger ones from Mr Gasket and they fit perfect.

Thanks, Is it located on the brake pedal itself.

I ordered these gaskets and strangely there a tad to small go figure.

Thanks for the part number these are the ones I needed. Much appreciated

On my 72 duster I’ve switched from power brakes to manual brakes due to putting in my 440 motor. I’m putting in a hurst line lock. Question; Is the Hydraulic brake light switch located under the dash on the brake pedal or under the car? Or was it on my power brake setup that I can’t find since I...

Your car is bad azz!!! I’ve saw the videos!!!

Thanks for the info on your car. I really appreciate it.

Another question for you. Is your car mini tubed and the springs moved in? What size rims with back spacing and tire size do you run. Beautiful car you have there!