Recent content by maxwedge413

Manley 426 Gen II Hemi Rods 7.1" NEW IN BOX - Matched set of 8 2.2" big end, 1.031 Pin bore, H Beam Manley Lot No 2580 W/O #: 118567 More than I need for my motors Power adder capable Ask $1200.00 USD OBO If the ad is up, they are available

That's an LA one. I need a B, 383/400. thnx

Mopar M1 383/400 intake, 4150 flange - pls let me know what you have and how much

They are a compromise.

That might solve some problems too

Not sure if the cat who bought out Schumacher is doing those again yet or ever. If he does, I wish he'd do 1 7/8" primaries and a 3" outlet. It would be great to get that potential with stock type ground clearances. My 1/4" x 3" Hookers are pretty good for ground and plug clearance but I still...

This is the old 90's Mopar Performance carrier. Takes 742 gears, which may be a bit limiting these days even compared to 489s.

Wish he would. Wish it could be through bolted on all 4 cap bolts too - not sure it's possible.

This one was hard to find. Got it courtesy of Bobzilla. Really nice piece. Nice to meet him face to face.

Very glad to have scored these, courtesy of Bigboy68. These have been hard to find. Now if I only could find some Chapman 260cc Stage 6 heads

Yup was taking with hi about that one - I'm looking at doing a low deck with S6 heads - so standard 440 width required. I have a couple of 230 casting 400 blocks I'm toying with doing a project with

Yes, thanks. That's how I understood it. I had hoped/thought there was one standard 440/RB sized one with the integral valley tray. A check of the old catalogues set me straight - no such beast. I hate valley trays on big blocks.... Still hoping to find the '383 part number standard port...

OK thanks for the clarification - I need one for S6 on a low deck - thanks!

Ah, I see that post - seems to be folks saying it only fits S6 on an RB with no spacers - ie; the extra wide intake is that correct? Or does it fit S6 on a low deck - ie; same width as a 440 manifold. Which is it? Thanks!