mbaird's latest activity
-
mbaird replied to the thread Stroker timing changes ?.I did . Smelled fine . Most every Edelbrock I have has done this to some extent . My theory is that having the jets in the floor of... -
mbaird replied to the thread Stroker timing changes ?.I set initial to 18* and on intitial drive up the street and back . the engine was shaking pretty bad. That could be the carb as well...
-
mbaird replied to the thread Stroker timing changes ?.That was my thoughts as well.
-
mbaird replied to the thread 71 Demon Trim identification/name.Possibly…. I don’t own a Demon anymore so I haven’t shopped for them . Someone here will know if they are the same as later year Darts...
-
Whoops, finally figured it out. The way to install Headliner side molding.
-
mbaird replied to the thread 71 Demon Trim identification/name.BTW … that headliner trim uses special clips that are unique to various years and models . Easy to get the wrong ones .
-
mbaird replied to the thread 71 Demon Trim identification/name.Belt moulding is the one on the door . I think the headliner moulding is just headliner roof trim ? That should get the right parts
-
mbaird replied to the thread Stroker timing changes ?.The point was to start a discussion explaining why the timing needs to change . Aspects like piston speed , cylinder filling, changes...
-
mbaird replied to the thread 700R4 for SB Mopar.Not really… I probably did more the neccesary. I cot the crossmember out and fabbed another out of 1/4” steel bar . But I could have...
-
mbaird replied to the thread 700R4 for SB Mopar.I am just finishing up the install of a 46rh and a 408 but in retrospect should have gone with a 42rh due to the smaller dimensions...
-
mbaird replied to the thread 700R4 for SB Mopar.What’s the advantage over a 42rh ? I don’t think you have to do much tunnel clearance work if any . The gear ratios are tighter...
-
mbaird replied to the thread Stroker timing changes ?.Once I start driving and tuning I will figure it out but conceptually I was curious.
-
mbaird replied to the thread Stroker timing changes ?.No.. I used a Scat 4” crank , scat rods and Scat Stroker pistons , I should have said that the only change was the 4” rotating assembly.
-
mbaird replied to the thread Kitchen cabinets if I live long enough to get this back together.Looks awesome!
-
mbaird replied to the thread Stroker timing changes ?.And compression increased 1 point to 10:1 Will the increase in compression offset the piston speed ?