Recent content by mjdcwo

I need them all and have heard some bad stories about after market moldings not fitting correctly. Any one had good luck with these and where did you buy them? Mike

Where is a good place to buy new wheel lip moldings for a 67 Barracuda? My old ones are in bad shape.

I bought the locking strip from Steele rubber and it worked fine in my old 67 windshield gasket and in the new rear window gasket that I bought from Steele for my 67 Barracuda. I bought it on line and had no problem. http://www.steelerubber.com/ Mike

Than you "Dart". That shows me just what I need. Mike

I need to retrofit to 134a and recharge my 1967 Barracuda A/C system. My question is where is the low side (suction) port located?

Thanks! Now I know what they look like. Just need to find two of them somwhere or I'll have to try and make them. Mike

My 67 fast back is missing the rear seat latch cams that go on the square stock pieces at both sides of the seat that activate the latch mechanism. Can anyone send me a picture of what they look like and/or tell me where I can get them? Any help is appreciated. Thanks, Mike

They are called "bowden" clips. Sorry, I don't have any extra. But I do need a headlight switch knob and shaft for a 67 Cuda. Some idiot didn't know how to push the button on the switch to release the knob and broke it off. If any one has one please let me know at [email protected]. Thanks, Mike

Will the glove box liner work in place of a glove box for a 67 cuda? I'm not familiar with a "liner". Mike

Kyjoe1969, I need the passenger side vent door. Will you email me and we can arrange the shipping? My email is [email protected] Thanks, Mike

Steve, Did you find the glass channel? Email me at [email protected] Mike

Actually, the Ballast resistor is there to keep the points from burning, not to protect the coil. The starter circuit by passes the ballast until you release the key to the run position. That is why when a ballast goes bad, the car will start and then quit as soon as you let the key return to...

Tim, I need a driver's door rear glass channel. Do you have that in you stash? Mike

Is there a part number actually on the one from legendary? I bought one 3 years ago from legendary and am just now installing it and the front bow tips as you described. Mine is a fast back. I wonder if I have the wrong one. Mike

Steve, The door measures 3 3/4" from the center of the door lock button to the rear top edge of the door at the end of the chrome strip on the outside. (See the door pic). The picture of the glass channel is from the Passenger door (right side). The one I need is from the Driver's side so I...