Recent content by MnDartSwagger

Thanks for the tip!

Does it have the steel reinforcing that comes with bolt on hoods? I need minimal weight. Thanks.

Not headed to Indy this year. Need to look a little closer to home. Thanks anyway.

Looking for a nice fiberglass lift off hood for a 1968 Dart drag car. Flat or with scoop, what do you have?

Hello, fellow FABOers! I am looking for a driver's door stainless steel belt line trim piece for my 1968 Dart two door hardtop. This is the piece of trim that mounts to the top of the door adjacent to the slot where the window goes up and down. Doesn't need to be polished, just not full of dents...

Hello, all. Is there a difference in the roof rail weatherstrip between a 1968 Dart 2 Door Hardtop with vent windows and a later model WITHOUT vent windows? I installed my roof rail weatherstrip this weekend. Fits in the stainless channel ok, but now vent windows bind big time on the fresh...

bump

As I understand it, the only year that the A body needed a locking strip for the windshield gasket was 1967...after that they went away from that design.

I am in need of: 1. Both vertical chrome windshield trim pieces 2. All exterior trim attachment clips (trim along top of doors) 3. Outer door handle actuator rods (the rod that attaches the exterior handle to the door latch) 4. Driver and passenger door window channel weatherseals (they run...

I am in need of: 1. Both vertical chrome windshield trim pieces 2. All exterior trim attachment clips (trim along top of doors) 3. Outer door handle links (the rod that attaches the exterior handle to the door latch) 4. Driver and passenger door window channel weatherseals (they run the...

Hello all. I know this is not a the ideal place to start this thread but what I need is too broad for the specialized forums elsewhere on FABO. I am looking for someone that has taken MANY pictures of their original or restored 1968 Dart 2 door hardtop. Pictures of the interior (front and...

This is a dedicated race car with an external SM switch panel with ignition on switch and momentary start switch. I also question the need for the Mopar four connection relay that you typically find on inner fender. With the schematic at the SM link, is it even necessary with the CD relay and...

Hey, cracked. I am going to wire my Dart like your schematic. When you offered your wire gauge description you mentioned a "Wire from CD* solenoid* to* Master disconnect switch" yet in your schematic I don't see a dedicated wire running from the CD to the switch. Would you elaborate a bit on...

Hello, all. I have a Indy Maxx 570" Hemi mounted in the engine bay of my 68 Dart Two Door HT. It is sitting in a mid-plate, too. I have yet to find a tranny dipstick that I can fit behind the valve cover. I have tried the big buck Lokar but it won't fit past the pinch weld connecting the...

Looking for a good right tail light housing for my 68 Dart. I have the lens and bezel...just need the "bucket". Shoot me a PM. Thanks.