Hungry for more? I can trade insults with you, if you like?
Here I am trying to learn and share, there you are being arrogant and azzy...
I won already though, cause I am in ya head.....
I have a job, I do not get to sit on my azz and critique other people. Get over yourself.
Your not so subtle insults are telling the world what type of arrogant jerk you really are. Your edits are telling.
Looks like to me trying to let the original poster know I had a set of the same head and I thought the numbers produced were good has created a lot of unintended strife. That was never my intent.
As stated, I am not a shop that produces or competes with anyone. I have just been comparing my...
Have a great day!
I am not hiding anything. It is not my fault poor reading skills and cognitive usage are in effect here.
YOU need to get off your arrogant hi horse and stop being a jerk. Having read through many of the comments you have posted all over this forum, you do have the ability to...
Again that is helpful info. I do compensate for temp and humidity differences when I flow the pipe unrestricted, explaining that may be an issue though.
I am actually searching for the plates mentioned between calls.
At least 1 poster here made some very snidely comments and he came across as a...
That is the type of info that is helpful!
Thanks.
I still maintain that I put a disclaimer on my numbers when I posted them. Evidently others didn't realize that or chose not to.
I plainly stated my homemade bench..
Again, thanks.
NOPE, I posted what MY bench did on MY heads. I never claimed my bench was the standard. Some of YOU made that assumption.
What I did say is the set of heads I have, that are very similar to what the original poster has, outflowed my unported Econo W2 heads. On MY bench by a bunch.
I do not...
From the stem down the valve, I am talking about a 15 degree angle cut, then a 30 degree angle, then the 45 for the seat.
Do you think that would help or hinder power?
Thanks for the info.
I explained my process in my post, I do not know what else to say. I use this bench for comparison on my stuff. Please don't take what I say as gospel by any means. It works for me and I did mention it was MY home made bench...... Take the numbers as you will.
I think a 15 degree angle on the valve face will also bring the numbers up but I haven't tried that yet. These are tulip style stems and the port work is impressive. But I can see only 2 angles on the valve face and the 15 degree back cut may help? Maybe one day I will get to it.