Recent content by moparfanatic56

Have the 4 shoulder belt clips with attaching screws and both coat hooks with screws out of a 72 dart black in color. I am asking 35 shipped in the conus from 61469 illinois.

Have a quick fuel sq650 mechanical secondary double pumper up for sale. I bought this quite a few yrs ago for my 340 put it on and it runs way too rich and I can't get it dialed in. The carb has maybe 20 hrs of run time and less than 25 miles on it, it will need new gaskets for the float...

Both chrome sold

2nd chrome ones sold pending payment

With my calipers I get 1.06 on the drum/drum master 1.115 on the disc/drum that sound right?

One of the chrome ones is sold

Pm sent with shipping cost

Have 3 master cyclinders 2 are chrome disc/drum type and the other one is cast drum/drum type, all 3 have been bench bled at some point and we're good. I am asking 35 each for the chrome ones and 30 for the cast plus shipping from 61469 illinois.

When I bought my 71 340 about 8 years ago it was just the short block, forged crank, stock rods and pistons bored .030 I gave i believe $400 for it. I had to have it sent to the machine shop to the tune of another 550 plus another 450 for a nice pair of 202 j heads. The going prices around here...

I am looking for the unicorn drivers side reverse lense with the stainless steel trim around the clear lense as shown in the attached picture. I currently have the 3 other lenses with this and really need the 4th. 1972 dodge dart but I believe these were on the 71's only and maybe the customs...

OK, I did a little research on this and there is supposed to a residual valve for the rear drum but not one for the front disc if the Mc is above the calipers and a residual valve for both if the mc is below the calipers. I also learned that if there is a residual valve the fluid will just...

No there is a slight jog in the tube and apparently it's a shadow making it look like it's bent. Good eye though always nice to have more eyes looking especially for an old blind guy like me lol

Here are some pictures don't know if they will help. I have checked diagrams on the plumbing for the distribution block and everything looks correct. I just loosened up the Mc and slid it out a little ways but there was no change or relief on the calipers. I guess what is puzzling me is after a...

That was one of the other tests that I tried was loosening the master cyclinder and there was not any pressure release on the calipers. When I pulled the dr diff kits it did show having to bend the tab for the outward pads some, but I have not tried that yet. I do not know if they are new or...