MOPARMAGA's latest activity
-
MOPARMAGA replied to the thread rusty valley tray..enough.Oh, yes indeed. The way my crap set up I had .060 on the head and .045 ...so that was expensive. This time around, 1 gasket for the... -
MOPARMAGA replied to the thread rusty valley tray..enough.Yes. @ $30.00 a set of you wanted Hughes brand.
-
MOPARMAGA replied to the thread Heads , 440.You'll have to figure out the length with a adjustable pushrod length checker tool. I don't know of anyone using factory rockers in...
-
MOPARMAGA replied to the thread Heads , 440.Well on the Dyno it's real easy. I don't know for sure but like I said the plug angle is very slight.
-
MOPARMAGA replied to the thread Heads , 440.The fenderwell headers are hookers. The spark plug boots have a lot of room., those are 2 inch primary also 1,2,5,6 angle back 3,4,7,8...
-
-
-
MOPARMAGA replied to the thread Heads , 440.Why ? You have fenderwell headers right?
-
MOPARMAGA replied to the thread Heads , 440.Angle plugs
-
-
MOPARMAGA replied to the thread Heads , 440.I think it will be just fine.
-
closed chamber and quench will aid in combating detonation.
-
MOPARMAGA replied to the thread Heads , 440.Yes big block. I think the other ones didn't get the r&d trickflow heads did. My pistons are above deck .012 , no issues Your pistons...
-
MOPARMAGA replied to the thread Heads , 440.It is a well designed chamber. Your cast iron head chambers are horrible. Aluminium dissipates heat way better, usually people can...
-
MOPARMAGA replied to the thread Heads , 440.All I did was adjust the springs for a installed height I wanted and that was it. The measurements trickflow said is what they were.
